You need:

Optional: cover the plate with paint.

• Using a pencil, draw a circle using the markers around the edge.
• Cut out using a utility knife or scissors.
• With the 4 mm bit of the hole punch, punch holes around the edge of the circle approximately every 1.5 cm.
• Cut strands of about 50 cm (cut longer strands to increase the difficulty).
• Thread the yarn through the eye of the needle and connect the dots randomly, until the yarn is used up.
• Once all the dots are connected, glue pieces of pipe cleaners and a pom-pom to form the rabbit's whiskers and nose. Finish with the eyes.


• On a sheet of foam, draw two large ovals and cut them out.
• On a sheet of foam or adhesive felt, draw two ovals slightly smaller than the first ones.
• Glue the small ovals onto the large ones, then the whole assembly to the back of the plate using a glue gun.

Through weaving and gluing, here is an original and very accessible rabbit!